[Konstrukter1]

Sorry for hijacking the thread. I wrote here, because its rigid tapping issue and forum is full practical the same topics....
To answer, yes I did this post myself. I have this structure practical identical for some other usage (High speed speeder,...) and i could write post for tapping in the same structure that Fadal show in their manual. But that is not what i would like to have.
So is there a problem to have G84.2 after H and if is it ok to simply add M5 after spindle start? Then again, thanks for P1600 tip (I will certainly add them all holes prior to tapping).

Best regards

[Konstrukter1]

So nobody knows answer? (So is there a problem to have G84.2 after H and if is it ok to simply add M5 after spindle start? ) Would code structure as this work OK for rigid tapping?

%
N1 O1 (D_DRILL1.NCC )
N2 (24-JAN-2016)
N3 (10:14:54) G17
N4 T2 M6 ( ** Tool 2 - Diameter 6.0 ** )
N5 G0 G90 S250 M3 E1 X-8. Y-10. M3 (Could stay, to start with program and with additional M5 stop the spindle and prepare my Fadal for tapping?)
N6 H2 D2 Z50. M8
N7 ( ** D-DRILL1 - DRILL ** )
N8 M5
N9 ( ** Tap tool M6.0** )
N10 G84.2 Preparation for G84.1 (Does need to be before H2? or is it ok to pt it here?)
N11 M00 Additional stop (Checked, double checked....)
N12 G0 X-8. Y-10. Z10.
N13 G98 G84.1 Z-5. R2.P100 S250. F250
N14 G80
N15 M5 M9
N16 X0 Y0 Z0 E0 H0
N17 M30
%
%

Best regards,
Franc