I recently setup a little 0.8kw high speed spindle, and found it very difficult to get an 1/8" ER11 collet into the closer nut. It works fine, and does a good job, and I do have another ER11 collet closer nut for the larger sizes, but the 1/8 inch collet won't come out of the nut now. (Yes before somebody asks I know to take the mill out first. LOL.) I can see where this could be a common issue with such a small total overall assembly, but is it normal? I'm just concerned that if I drop a 3mm collet or a 1/16" collet in my other nut that it will also become a permanent assembly. I suppose I could always buy a handful of ER11 collet closer nuts. One for each of the smaller sizes. LOL.