Proma THC, Everlast PP80s, SheetCAM, Mach3

Been trying everything over the past few days to get this to work as I'm trying to cut 18g and it lifts and warps like crazy.
Current my hardware has a Floating Head with a NO switch on it wired to the ZHome.
Proma THC activates the Z axis properly in test mode.
Using SheetCAM Post Process for "Plasma post processor for generic THC system s such as Proma Includes backlash compensation and punch marker"
Switch Offset set measured at .115" and converted and inputted into PP as mm (appr. 2.9mm if I remember)
I set the beginning Zaxis just above the plate. (everything from just touching to 1/2")

Now the problem. At the beginning of the process the torch travels down to the zero I set, not the limit switch and then travels up to infinity until I stop or I trigger my switch.

I've tried a bunch of different active high/low settings and a few other things.

Pulling hair now!!