[Abs9]

Hi,

I am looking to buy a new VMC. It has a Mitsubishi M720vs controller.
Can anyone help me to get the postprocessor for the same.
I have sprutcam 7 which I received with my Tormach.

Thanks and Regards
Abs

[MichaelHenry]

I can't help directly with the Mitsubishi post, but in case you didn't know, I believe that you need the "all posts" version of SprutCAM that Tormach sells in order to do a post for a non-Tormach machine.

That said, did you check the posts that came with SprutCAM to see if there is one for a Mitsubshi control?

Mike

[Abs9]

Hey thanks. I guess i have an all post version.
Dont have mits in the standards though

[MichaelHenry]

Too bad it's not in the standard list. You could either ask Sprut to create one for you or see if they still make the free Post editor available and create your own. You might also find a standard post that works for what you want to do.

Have you tried Dave on the Sprutcam forum?

SprutCAM forum (Powered by Invision Power Board)

Mike