I have access to a little CNC router (15x17.5 table) with a Xylotex controller and older version of Mach3/Easycam.

I design simply parts in AutoSketch 9 and import them into LazyCAM. I can then set the lead-in and lead-out in LazyCAM.

But the question I have is, could I achieve the same lead-in and lead-out by designing that into my drawing in AutoSketch? I kind of envision adding a small (.25") line on the outside or inside of a shape, and telling LazyCAM to start the routing there.

I obviously don't have a ton of experience in this area, I don't know if this is possible or desirable. Just wondering if this would be an easier way.