[neilw20]

I know this is an old post however I've searched and can't find anything on the "timing requirements" for the Syil stepper driver. The driver PDF above doesn't say what the minimum or maximum timing requirements for this driver are. This thread comes up in Google searches so thought it might be useful if an answer can be added here.

What are the minimum pulse or step timings for the Syil Supper Diver?

Once I can get all the information together and can get my Syil X3S working on LinuxCNC I'll put together a post on the required settings for anyone else that wants to change over from Mach3. Unfortunately my Mach3 PC died so I don't have the original settings to help with setup.

Minimum andaximum timings? On a squarewave? I bet the steepper motor misses steps before you hit that limit.

If you don't backup for a year, you are prepared to lose a years work.

Mach3 manual is quite concise and clear. Parallel port, pin numbers, and all.