To All,
Photos will tell everything.
My parameters: Cut2d, linux emc2, 1/16 endmill, k2cnc 25 x 14 table
Thanks
To All,
Photos will tell everything.
My parameters: Cut2d, linux emc2, 1/16 endmill, k2cnc 25 x 14 table
Thanks
Looks like some deflection when you're plunging. Find out if the machine is flexing anywhere.
Try ramping in and out, and overlap the start and end points a small amount.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)