586,364 active members*
3,123 visitors online*
Register for free
Login
IndustryArena Forum > WoodWorking Machines > Commercial CNC Wood Routers > K2CNC > K2CNC Doesn't work after upgrade to Windows 8.1

Thread: K2CNC Doesn't work after upgrade to Windows 8.1

Results 1 to 3 of 3
  1. 05-14-2014, 06:08 PM #1
    jmerrill9
    jmerrill9 is offline Registered
    Join Date
    May 2014
    Posts
    11

    K2CNC Doesn't work after upgrade to Windows 8.1

    I have a K2CNC 25x25. Until yesterday it was working fine with Windows 8.0, KMotion, and kflop. Then I decided to upgrade to Windows 8.1 and now the computer no longer talks to the control box. Windows device control panel is saying that the kflop drivers are no longer installed so that is probably the cause. Does anybody know if there are drivers available that work with Windows 8.1? I appreciate any help I can get!

    Thank you,
    Justin
    Reply With Quote Reply With Quote
  2. 05-14-2014, 07:44 PM #2
    jmerrill9
    jmerrill9 is offline Registered
    Join Date
    May 2014
    Posts
    11

    Re: K2CNC Doesn't work after upgrade to Windows 8.1

    OK I think I fixed it. Reinstalled the driver after disabling signature permissions. Computer and control box now say they are connected. I'm going to take them back to the shop and reconnect to the CNC to make sure it is truly working. Crossed fingers
    -Justin
    Reply With Quote Reply With Quote
  3. 05-17-2014, 12:55 AM #3
    jmerrill9
    jmerrill9 is offline Registered
    Join Date
    May 2014
    Posts
    11

    Re: K2CNC Doesn't work after upgrade to Windows 8.1

    Everything is good again
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 18i upgrade from Windows 98 - 2000
    By C-sCnc in forum Controller & Computer Solutions
    Replies: 1
    Last Post: 01-28-2016, 12:47 AM
  2. G10L50 doesn't work
    By martyc@blumlmt in forum Fanuc
    Replies: 8
    Last Post: 09-05-2012, 09:53 PM
  3. probe doesn't want to work
    By metalmansteve in forum Haas Mills
    Replies: 6
    Last Post: 06-25-2012, 10:38 PM
  4. G72.1, G72.2 doesn't work!
    By Maxz in forum G-Code Programing
    Replies: 7
    Last Post: 11-18-2011, 05:16 PM
  5. SmartCAM NT upgrade for Windows
    By eei in forum Uncategorised CAM Discussion
    Replies: 0
    Last Post: 03-29-2010, 11:47 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules