Hi all,

I have recently taken over a position and am now working with a 2 x 4 Torchmate with a Powermax 65 plasma. I have been following the manual for best settings and have tried new consumables in the machine however I am still getting excess slag on the underside of material and also a bevel on the edges which I think is excessive.
All files are sent from the designer as DXF
Last cut was 2.5mm Stainless sheet 304 with speed of around 100ipm, 0.6mm from job, 45A and using finecut consumables. Also 8mm mild steel using 65A shielded also gets a large bevel.
Any help much appreciated

Pictures of the 2.5mm stainless cut