Waterjet. X & Y are servos. Z is a stepper. Upgrading from SmoothStepper because I want c losed loop control on X &Y with linear encoders.
Everything setup on Kanalog. Can jog using KMotionCNC. Encoders are working in KMotion.

1) Mach3. Config. Ports & Pins. Do I enter an address for Port 1 and 2?

2) X & Y are analog. Do I enable them in Motor Outputs, or just the Z (stepper) axis?

3) KMotion. Axis. Enable activates closed loop control. Hitting a limit switch disables. I am using Opto 6 and Opto 7 (Kanalog bits 150 & 151). How do I turn these on/off instead of Enable?
3A) How do I turn Enable back on?