I have a new handwheel to my cnc controler The output signal is typ open collector (signal A,B A-,B-) The interface in the CNC controller
is TTL logic How to connect the Handwheel ?
Tommy Ollevik ([email protected])
Sweden
I have a new handwheel to my cnc controler The output signal is typ open collector (signal A,B A-,B-) The interface in the CNC controller
is TTL logic How to connect the Handwheel ?
Tommy Ollevik ([email protected])
Sweden
Use 5v with a 330ohm pull up resistor to 5v.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.