[Nutsack]

Hi gang,

Some info, the screw head has a recessed bore in the middle for a logo sticker .0625 deep. I don't have the access or knowledge to use any CAD programs so the bidding parties will have to be responsible for that. Anodizing capabilities are a plus but not required

Please ask any questions as I know my drawing blows pretty bad.

I am looking for quotes for 50, 85, and 125 to start and then more runs to come after demand has been established. Also looking to get other small aluminum parts made in the near future. All geographic locations are welcome

You can pm me here or call/text with any questions 574-250-6900. If I don't answer that means I am likely working and please leave a message. I'll call back asap.

Email is [email protected]


The threads are 8-32 X 9/16 machine thread
Measurements are in inches

[wayne.penhollow]

Do u have contact info


Sent from my iPad using Tapatalk

[Nutsack]

Yessir. Call or text at 574-250-690zero

or email [email protected]

[Nutsack]

Ok folks, thank you for the quotes. I retooled the design to make it a little easier to machine. Thank you for the interest