586,608 active members*
3,596 visitors online*
Register for free
Login

Thread: ez trak BMDC card led.on or off

Results 1 to 2 of 2
  1. 04-10-2014, 09:55 AM #1
    nealg
    nealg is offline Registered
    Join Date
    Sep 2005
    Posts
    26

    ez trak BMDC card led.on or off

    Hello everyone
    Just a quick question
    On the BMDC card should led lights be on or off
    In the picture number 1 red in on,2 red is off and
    3 is flashing green.
    Is this right after boot up or should 2 be on as well if so what could cause this.
    Also could this cause dac overflow in y when homing.

    Regards
    Neal
    Reply With Quote Reply With Quote
  2. 04-14-2014, 03:00 PM #2
    cncfixxer
    cncfixxer is offline Registered
    Join Date
    Oct 2013
    Posts
    57

    Re: ez trak BMDC card led.on or off

    When I get a normal boot ... the 2 red led's on the top are off but the red LED on the bottom is on until I home.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. EZ-Trak 6.00_5.78 software on a EZ-Trak SX mill causes Initgrafix error
    By Greatdaen in forum Bridgeport / Hardinge Mills
    Replies: 6
    Last Post: 08-31-2021, 04:07 PM
  2. EZ-Trak 6.00_5.78 software on a EZ-Trak SX mill?
    By Greatdaen in forum Bridgeport / Hardinge Mills
    Replies: 0
    Last Post: 09-23-2013, 11:26 PM
  3. BMDC
    By tpmx57 in forum Bridgeport / Hardinge Mills
    Replies: 6
    Last Post: 06-17-2011, 02:16 AM
  4. BMDC
    By tpmx57 in forum Bridgeport / Hardinge Mills
    Replies: 0
    Last Post: 10-12-2010, 07:42 AM
  5. Need BMDC and PWMINT card pinouts
    By 762x51 in forum Bridgeport / Hardinge Mills
    Replies: 1
    Last Post: 03-29-2010, 07:14 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules