Hi all
I have a XJ1212 running with NCStudio. I must say i have had absolutely NO issues and has been stable from day 1. I am running at 0.001 resolution on all axis. However this is probably TOO high.
So i was looking at the specs - my machine should Jog at 7000mm/min and cut at 4000mm/min. The max i can set to in NCStudio is 2820. Any higher and I get an error when i click to apply the higher setting.
I thought perhaps it was the resolution, which made sense, so i adjusted the drivers and NCStudio to 0.01 resolution. It still seems the max i can set NCStudio to is 2820.
Any ideas?? Will be a HUGE help.
Thanks.