[bevins]

I retrofitted a machine and I am trying to get the spindle running. I am sending it the correct 0-10v and setup the inputs, but no spindle movement.

Driver B-53425E, with A20B-1001-0120 spindle board and A20B-008-0030/050C orientation board

Servo A06B-1003 B300

servo readey setup:

gnd to pin 47 CN1 ESTOP
gnd to pin 7 CN1 MRDY READY
gnd to [pin 45 CN1 SP Forward
sent 0-10v to pin 31 VCMD-1 DA0 and gnd pin32 VCMD-2


I hear the contactor in the drive when I send gnd to pin 47.

Anyone have manual that shows wiring etc....?

Any Ideas?

Thanks in advance,

Bob

[bevins]

Problem regulated. Thanks

[calavera1975]

Hello, could you tell me how you solved it?
I bought a new control and wanted to use the servo spindle with its servo motor.