Hello, I am running SprutCAM 8 Build 1.0 Rev 63896 x86
I am working on setting up two different machine offsets G54 & G55, but before I had reached that point I thought I would try and machine the parts from one workpeice .
With two identical parts (GoodPart) it runs fine. When I change the size in X and Y of the second the tool crashes (BadPart)
Roughing Waterline Operation GoodPart
Attachment 230208
Results of Simulation GoodPart
Roughing Waterline Parameters GoodPart
Roughing Waterline Operation BadPart
Attachment 230214
Results of Simulation BadPart
Roughing Waterline Parameters BadPart
I am new to SprutCAM so the problem is probably operator error!
I was actually able to use the two identical parts (GoodPart) to use G54 and G55 to machine the individual parts.
Attachment 230198 Attachment 230200
Attachment 230202 Attachment 230204
I have attached the files
sprut_Files.zip
David