Hello Everyone,
I am looking for help from an Expert on Gear Hobbing using a Liebherr CNC LC 152.
Anyone with knowledge on Part Programming , please reply.
Regards
Abhay
Hello Everyone,
I am looking for help from an Expert on Gear Hobbing using a Liebherr CNC LC 152.
Anyone with knowledge on Part Programming , please reply.
Regards
Abhay
ABHAY
Track down John Stevenson on Home Shop Machinist. He has built CNC gear hobbers from scratch I believe. That board is at:
http://www.homeshopmachinist.net/bbs...isplay.php?f=3
Also try Practical Machinist for help:
http://www.practicalmachinist.com/cg...ultimatebb.cgi
Best,
BW
Thank you Bob Warfield.
I will check out both the leads.
ABHAY