Hey, I have been operating my machine for several months with (little to) no issues. The other day I had multiple occasions where during machining I would get "External E-stop requested" and I'd have to unplug the g540 power supply and re-start. On the last one though, I got the same error but now I cannot get my g540 to come out of fault mode.
Even with unplugging all the motors and turning the charge pump off I can't get the green light to come on. If I read this correctly, then turning charge pump off should always give it a green light.
Is there something else I could try to get it back into 'green light' mode?
It doesn't seem like I would need to rewire anything, but I'll try it if nothing else works. Thank you very much for any help. I am completely clueless right now.