Does anyone know the exact location of the 4 holes (M12) on the back side of the base (in MM/IN) from the top & left/right side? There might be slight difference in between 2010 and later models.
Does anyone know the exact location of the 4 holes (M12) on the back side of the base (in MM/IN) from the top & left/right side? There might be slight difference in between 2010 and later models.
is yours a 2010 model? what are your measurements as they can vary a little from machine to machine as the chinese aren't real careful about hole placement. i think they go by eye with handtools.
am
Am, my G0704 is 2013 model. I wanted to avoid the Z post dismounting, so at this point I can only get the approximate data.
alright but the 2010 reference doesn't make sense then, i can't give you that data as mine is still together as well.
am