[Raf-1200]

I have a 909 x 600 tabletop router. It has a fairly decent spindle on it (water cooled)

Now here's the bit where I open myself up to ridicule and damnation. This is only the second part I've produced with cnc. I know it's not as strong as a mill but here's what I'm cutting and the rates etc.

6061 aluminium.
6mm end mill carbide
68 mm per minute feed rate
.65 overlap
Spindle speed 6000
1mm depth cuts

I know it's slow but at least it works lol. Is there a table or program I can use to shed light on my haphazard techniques?

Ok fire away....


Mostyn Cafe n Customs Homepage Mostyn
Cafe Racer and Custom Bike Builds

[Raf-1200]

While changing my operation from contour to hatch I missed changing the depth setting. As a result I found out that in fact my little machine will do 5mm depth cuts with .65 overlap.

Feedrate and spindle rate remained the same.


Www.mostynindustries.com.au
Cafe Racer and Custom Bike Builds

[interzis]

Look for GWizard, will help you a lot

Sent from my Vodafone 975 using Tapatalk