Hi dear friends, i bought tachus42 driver board months ago and it works with motors in mach3 but it burned , and i replaced it with another one also tachus42 but from another shop , but this time it works with some in kcam - he send me the setting files, but not working in mach3 - i downloaded the profile file from the official website, but not works,
i notices the setting in the two files are same ; i attached it
it's my parallel port , :
Attachment 214090
Attachment 214092
i tried step and dir 1 , 0
Attachment 214094
this is the setting in kcam :
Attachment 214096
i hope you have solution , i need it to works in mach3
thanx