[jorgito316]

Please would you help me in my module, in the 7-segment display I get the number 12 which I presume is overcurrent error, check the power and SEMIPACK well I would like to know which circuit to measure or which component is the I cause this error. This alarm only comes when I want to start the servomotor.

My module is A06B-6078-H211 - 230V 48A
Splinder Amplifier.

Thanks Regards

[Heavy_Metal]

Hi,

I think you need the Fanuc B-65165E manual.

Check here for download;
http://www.cnccenter.com/pdfs/65165e.pdf
Look at page 88 of the pdf-manual (page 94 of the pdf-reader) for ALARM AL-12 (Chapter 3.4.7)

or this one;
http://fanuc.pennineuk.com/library/pdf/AIMANUAL.pdf
page 117 - ALARM AL-12 (also Chapter 3.4.7)

I hope this is what you are looking for.

Regards,
Heavy_Metal.

[guhl]

disconnect motor and try again, if alarm occures and after, check output of spindle amp by multimeter