We have a mid 90's HS1 Haas mill & the send/receive board is obviously bad. We can send programs to computer but we can't receive them. Is there any way we can replace this board with a USB port or floppy? Haas quoted us $3k for the board & I'm thinking we can replace it with USB but I figured I'd ask to see if anyone else has done this? Thanks
Results 1 to 2 of 2
-
11-09-2013, 07:24 PM #1
Registered
- Join Date
- Sep 2007
- Posts
- 30
Haas HS1 RS232 in/out board only sends out
-
11-11-2013, 11:00 PM #2
Junior Member
- Join Date
- May 2012
- Posts
- 67
Are you talking about the little RS232 board that has the D-sub connector on it? If so, that shouldn't be $3000. The hardware that affects the RS232 send/receive function are the RS232 card, Processor PCB and the Video PCB. It sounds like they quoted you up on a processor. If that is the case, let the HFO replace the processor. I want to say the video board is around $400 after the core exchange, maybe try replacing this first. As for an upgrade, your guess is as good as mine.
Good luck
Reply With QuoteSimilar Threads
-
Haas rs232 dnc
By duckslayer in forum Haas MillsReplies: 4Last Post: 09-28-2010, 02:27 AM -
Wireless RS232 on Haas - anyone doing this?
By samhyto in forum Haas MillsReplies: 12Last Post: 04-22-2010, 12:33 AM -
Mastercam X4 to RS232 Haas Mill
By DaOne in forum MastercamReplies: 5Last Post: 02-03-2010, 04:59 AM -
FADAL RS232 BOARD
By cncfish in forum Want To Buy...Need help!Replies: 0Last Post: 07-08-2009, 01:34 AM -
RS232 cable to run onecnc on haas?
By turboboy in forum OneCNCReplies: 5Last Post: 04-17-2008, 02:49 PM
Posting Permissions
