[rstbkt]

I have watched a lot of videos and I think the videos were done well enough for me to start with a few simple parts. If I did my configuration right. LOL. I was wondering if BobCad had a user manual so I can explore all the toolbar pulldowns and what they will help me do. As good as the videos were they only covered the basic tools needed for the demo. I downloaded the getting started manual and I admit I only used it for setting up the machine requirements and just browsed the rest of the document, I didn't see anything like what I was looking for.
Jim P

[jrmach]

What Version ?

[Trotline]

The Help files in both V24, (built-in) and V25, (web-based), have been pretty good for exploring individual functions. The format might take getting used to, but the documentation is really pretty thorough. It's how I learned all the basics, and got me to the point where I could follow most of the conversations on this forum, which is very much like Grad School for BobCAD.

Luke

[jrmach]

Some of these links are no longer,,,sorry,won't allow me to edit.Anyhow,a lot of these are pertinent to V23,24 &25.

http://www.cnczone.com/forums/bobcad...formation.html


Again,what version are you using ?





Trotline,
isn't it about time to pretend to grow some new fake plants ?

[Trotline]

That's a good point!

Luke

[rstbkt]

Useng V25. Sorry I forgot to add that. The videos I have watched have been mostly V24 so far. My problem is knowing what the processes are called and if they are only in Pro versions. Thanks for the links and suggestions. I'll delve into them.