How can the c10 breakout board be wired for a 5th axis and can Mach3 run it?
Thanks!
How can the c10 breakout board be wired for a 5th axis and can Mach3 run it?
Thanks!
Yes and yes, configure C10 pins 16 & 17 for B-axis.
See link below for a six axis screen set if you do not want to design your own.
This thread explains more in detail.
New (revised) Mach3 6-axis screen
Hope this helps,
Jeff...
Patience and perseverance have a magical effect before which difficulties disappear and obstacles vanish.
Thanks Jeff!
Would this be right.......
PUL- to 16
DIR- to 17
PUL+ to GND ??
Thanks