Hi to all,

I have an EZ Trak 3 axis with the .pgm system .When the machine goes to home position I get this alarm:

"Commanded X Axis move too far / Positive"

1. We already changed the X motor with a new one, Interchanged the X motor with the Y motor including the drive.
2. Re-installed the operating system.
3. Verified the X adjustment with no success.
4. Manually tried to jog the X axis with no success (still get the same alarm)
5. Re-set the computer


IF any knows about this situation please sen a e_mail or call 7873174815

Héctor Zayas
M.E.
HAMILTON SUNDSTRAND Puerto Rico
Machining / Cores / Repair Center
Phone: (787) 845-4343 Ext. 1639
Cell : (787) 207-3981 Fax: (860) 660-9894
[email protected]
Felicia Industrial Park
Street B Lot 9 Blg. B
Call Box 2805
Santa Isabel, PR 00757