[jalessi]

TrickyCNC,

Did you try viewing the other fonts listed?

[TrickyCNC]

Yes... if you click on them it says BuyOnLine

[jalessi]

Maybe this might work for your project:

Pacifico font by New Typography - FontSpace

http://www.fontspace.com/category/cursive

[urbnsr]

Maybe this might work for your project:

Pacifico font by New Typography - FontSpace

Thank you very much!
Paul

[TrickyCNC]

Thanks , for the suggestions
I was just about to buy Susa... but then it starts asking me for registaration etc etc ... so I thought I'd check here before I went through all that ! ...
I'm cutting out the words, so Susa suits well because it has not tapered lines ... it's pretty uniform.

Looks like I'l register and buy it

Thanks again
Rich

[J. Marti]

Attachment 205066
Attachment 205068

Here are 2 pictures of the sprockets I cut. The second picture is the sprocket next to a stock 1952 Monark Bicycle one.

J. Marti

If you are looking for shareware try Inkscape or Win-topo.

Your artwork is terrible, much higher resolution is necessary if you want crisp lines.

Hope this helps,

Jeff...

[troyerscnc]

Thanks for the grape drawing KKBERG . What kind of bits do you use to cut it? Also any more grape clusters for carving? Im new to cnc and trying to learn how to carve them.

[Larry83301]

Thanks for the grape drawing KKBERG . What kind of bits do you use to cut it? Also any more grape clusters for carving? Im new to cnc and trying to learn how to carve them.

Steve Good had this on his site. Perhaps it is something you would like! :wave: :wave:
The left hand part goes over the right hand part.

Larry

[kkberg]

I use 60 degree V-bit, but it depends on how you want to engrave it.

[ryke]

Any one got Christmas dxf's of any kind? looking for ideas to laser cut

[garciacnc]

Would someone be able to convert this image to dxf?

I have seen one of Christ's face on a cross but I understand it is impossible to get and I want to make something for a friend so this will have to do.

I can make this for you in 3d as a dxf file if you are still looking for it.

[JMATTINGLY]

Hey, was just checking out your pic... very cool. I can in 2d and it will take some time. let me know if your still in need. (JM)

[LEARN]

who cam make these dxf files ? and or how is it done

[leespc]

Good day all. Can some one please help this NEWB out? I need to convert this jpeg to a burnable (plasma) dxf any help would be greatly appreciated.Attachment 207054

[urbnsr]

Good day all. Can some one please help this NEWB out? I need to convert this jpeg to a burnable (plasma) dxf any help would be greatly appreciated.Attachment 207054

Try this for a start.

[ryke]

would someone like to convert these to a dxf for me?

[twoclones]

would someone like to convert these to a dxf for me?

I tried to trace it but the results were not good. A larger image would give much better results.

[jalessi]

would someone like to convert these to a dxf for me?

Ryke,

I accept bribes,

Jeff...

[ryke]

can either one of these work?
what would your like
thanks for helping

[twoclones]

Ryke,

I accept bribes,

Jeff...

Jeff,
When I tried to open your dxf in AutoCad LT is says "invalid or incomplete"
Any idea why?

Butch