[AleksanderA]

Hi!

I would like to build a printer like this one:
Delta Ceramic 3D Printer - YouTube
The parts I already own are Gecko drive - G540 4-Axis Digital Step Drive:
and Nema-23 motors (guess I will need only three), power supply.. Other stuff
like linear grids, bellts and pulleys etc are allredy ordered and will probably arrive soon..
The problem is, I don't know what software is appropriate for generating the G-code and driving the printer
in my case. I'm just a digital artist
Can anybody help me?

Thank you for any answer!

Best regards!

Aleksander

[whateg01]

Sorry, I like the idea of building one of these, and I applaud anybody who does. But, shouldn't that have been a consideration before you started to acquire the parts? I hope somebody is able to point you in the right direction.

Dave

[AleksanderA]

Sorry, I like the idea of building one of these, and I applaud anybody who does. But, shouldn't that have been a consideration before you started to acquire the parts? I hope somebody is able to point you in the right direction.

Dave

The machine I have builded with this parts by now works like this:
https://www.youtube.com/watch?v=IQVivZg3vwg
...and I cud do the delta version as well
Have an applause for your quick and smart reply David.

Aleksander

[bhurts]

I like it. Never had any practical ideas for a 3d printer because I can machine much higher quality parts. I never thought of printing ceramics. That is awesome. Finally a diy 3d printer I can get on board with. Oh and I noticed your first post was from 2013 so you had plenty of time to figure out what to do with your parts. 😉 Great job.

Ben