Mountainwildman: You have contridicting statements in your message.
If you want N#'s, set omitseq = 0 (or no). Then you'll get sequence numbers. If you say 1 (or yes) you are omitting sequence #'s.
If you want to control the numbers to start at 1 & incr by 1 (1, 2, 3 etc) that's controlled on the parameter page (for V9) or in the Properties , section in the Operations Mgr (in X).
Mike Mattera
Tips For Manufacturing Training CD's, DVD's for Mastercam, SolidWorks, Inventor, G-Code Training & More
http://www.tipsforcadcam.com