I'm trying to mount a cnc and I have some problems with the driver Haoyu tb6600.
- Power supply 45V 500W
- Haoyu tb6600
- Breakout board cnc4you HG07
- Stepper motor kl23h286-20-8b
- PC / Mach3

When I connect the power, the motor is energized and PWR LED on, but when I make to moves the motor (Mach3) then the leds RUN WARN switched on and the motor does not move. And also that happen also without the motor.
Attachment 195194
Attachment 195196

Did I connected the wires wrong?
Did I have fried the chip?

Thanks