Hi Good Day to all,
I decided to build my own cnc router and i got a package off ebay with the following.
-Brake out Board
-Longs S-201-60 Power supply (+60v 3.5A)
-Longs DM860A Driver
-Longs Stepper motor model 34HST9805-37B2
-used 5v supply from pc power supply
i am using Mach3 to run it, i have windows 7 32bit installed on a dedicated pc for this project.
I hooked it up but got no movement at all, i am not even sure if i hooked it up correctly, or if i configured mach 3 correctly. Is it possible for someone to guide me through this wiring/ config process?
thanks
Saalih