Mastercam X6/Charmilles help
Alrighty guys, I have a question about some of the code Mastercam X6 is spitting out for the Charmilles 300 I was just trained on. I keep getting "D" codes that are sequential like...
"D0" for rough cut
"D1" for first skim
"D2" for second skim
"D3" for polish pass
Problem is, the edm needs all "D0"s to run and I am not sure where to change this in Mastercam in order to post a nc file that does not need manual editing.
Thanks in advance for the help.
Thought I knew it all then God and life informed me otherwise. I am so glad they did because humility is a far better virtue when compared to arrogance.