Hello everyone. This is all new to me so hopefully won't waste anyone's time. I have just purchased a Bridgeport Series II Special milling machine fitted with an Anilam 3 axis controller 3300MK. Everything is like brand new and the machine was fully operational when demonstrated. After shipping and installation into my premises I am getting an error message when I power it up. ERROR... CANNOT DETECT MOTION CONTROL BOARD. I get a prompt to continue, press F10. This does nothing. I have tried pressing clear and enter. I have check the E-stop and servo reset etc and check all the limits. I have tried all these steps in manual and auto mode. I can't manually operate the spindle or any of the servos. I don't know where to go to next. Can anyone help?
Regards Ray