[test29]

I have board TB6560 and stepper motors NEMA23 - 57BYGH633, connected and working.

My question is:

This motors are 3A and I don't know if I should leave current setting on board (75%) like it have came shipped or I should change it to 100%?

Motors are tried with 75% and working, but if they are 3A should I change settings to 100% to have more power?

Thank you.

[moosecnc]

I know this isn't an answer to your question but I've been scouring this site and others on how to get my setup running. Your steppers are 6-wire so how do you have them connected. I've looked at the setup sheet for my controller and data on the steppers and I can't get anything to work. Any help you can provide is greatly appreciated.

[H500]

To connect a 6 wire unipolar stepper to a 4 pin controller, use the center lead and one of the outer ones from the same phase. This is known as the "half coil" configuration.

[longs_motor]

About the 6-wire,there are 2 ways to connect themne is high torque and the other is high speed.it is according to your requirements on machine.
For example:
longs motor 23HS8630 6-WIRES.
High torque: BLK A+,GRN A-,RED B+,BLU B-,leave others alone.
High speed: BLK A+,YEL A-,RED B+,WHT B-; YEL A+,GRN A-,WHT B+,BLU B-
You can try it later.:-)
Any questions,you can send email to us: [email protected]