http://www.anaheimautomation.com/man...ct%20Sheet.pdf
MBC10101 drive specs:
20 - 80 VDC
1.5 - 10 A
2000 steps per revolution
$118.74
Would this drive be better than Geckos? I may have found some cheap 9A steppers and the Geckos are only good for 7A.
Results 1 to 3 of 3
-
03-07-2006, 07:33 PM #1
Registered
- Join Date
- Feb 2006
- Posts
- 3
Anyone use Anaheim Automation MBC10101 drive?
-
03-08-2006, 05:46 AM #2
Registered
- Join Date
- Feb 2005
- Posts
- 750
I havent used one personally, but I have another one of thier old drivers that works fine. Theyve been around for a long time. Those are impressive specs for that price. Looks like its worth a shot, at that price.
Halfnutz
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
12-21-2006, 07:25 PM #3
Registered
- Join Date
- Mar 2003
- Posts
- 104
I have an Anaheim automation driver board mounted in between
two Gecko 202's. They all seem to work good.
Jimwww.outbackmachineshop.com
Reply With Quote
Posting Permissions
