I'd try it in one pass with a 12mm (1/2") 2 flute compression at 16,000 rpm and 400ipm. If your spindle is up to it, you can probably go up to 500ipm.
I'd try it in one pass with a 12mm (1/2") 2 flute compression at 16,000 rpm and 400ipm. If your spindle is up to it, you can probably go up to 500ipm.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)