Interesting project:
We have to tap 100+ #10-32 blind holes (0.200" depth) in A36 (low carbon plate) in a VMC .
Which would be better ?:
Bottoming form tap
Bottoming spiral flute tap
Interesting project:
We have to tap 100+ #10-32 blind holes (0.200" depth) in A36 (low carbon plate) in a VMC .
Which would be better ?:
Bottoming form tap
Bottoming spiral flute tap
An open mind is a virtue...so long as all the common sense has not leaked out.
Thread mill.
Took a brief look this morning for one, Emuge has them.
I'm sure there are others as well.