586,094 active members*
3,895 visitors online*
Register for free
Login

Thread: Convert MO-CON501 Pendant controller

Results 1 to 2 of 2
  1. 02-27-2013, 07:05 PM #1
    Freddierout
    Freddierout is offline Neuer Benutzer
    Join Date
    Feb 2013
    Posts
    0

    Convert MO-CON501 Pendant controller

    Hi Guys,

    I have recently purchased a chinese cnc router (8 x 4' bed) 3 axis. However, my other CNC router run Mach 3 and i would ideally like to run this on the new machine.
    Anyone offer me advice on how to convert a MO-CON501 Pendant controller to
    Mach 3.
    I understand i will need a breakout (interface board) but don't know if i can buy this of the shelf?

    Thanks Nige
    Reply With Quote Reply With Quote
  2. 09-04-2015, 08:02 AM #2
    imasinner
    imasinner is offline Junior Member
    Join Date
    Sep 2015
    Posts
    1
    hi, did you make any progress with this, as i have the same controller, its a bit limited, and would like to use MACH 3 to control my machine
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Interfacing MO-CON501/Little blue TB6560 manual controller
    By Mike4703 in forum CNC Machine Related Electronics
    Replies: 53
    Last Post: 10-22-2011, 04:08 AM
  2. CNC Mach3, Jog Pendant(Controller)
    By Robiz in forum News Announcements
    Replies: 0
    Last Post: 06-28-2011, 02:56 PM
  3. CNC Pendant Controller Kit- LOW COST
    By Motiondrives in forum News Announcements
    Replies: 5
    Last Post: 03-17-2010, 09:24 PM
  4. diy cnc controller? pendant?
    By bp092 in forum DIY CNC Router Table Machines
    Replies: 2
    Last Post: 10-30-2007, 11:18 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules