[Rick_B]

I trying to get my mill which I just got running, I got my homing problem/alarms worked out. But the Led in the SPDL stop button is on, and the 407 that comes up at the top of the screen which I though was an alarm is not an alarm at all but a program which looks to have been running when the machine was first shut down. So my question now is, how do I stop the machine from wanting to finish it ( if that's what its trying to do) and how do I delete that and the other that are there?, and how do I get the Led to go off?

Rick

[Rick_B]

The note in the manual said :-

"NOTE
The LED in this pushbutton is ON if the spindle is stopped during an AUTO
CYCLE interrupt condition, to act as a reminder to restart the spindle
before the cycle can be resumed."

I'm trying to workout how I do this.

Rick

[Al_The_Man]

I would have though a reset would have done it? What control?
Also some of these conditions depend how the MTB configured the machine.
Can you run or start the spindle in MDI?
Al.

[Rick_B]

The controller is a Fanuc OI-Mate MB. I tried starting it in MDI but nothing happened.
MTB configured? What is this? were do I look for it? I'm new to this it's my first CNC

Rick

[Rick_B]

I got it worked out. It turned out it was a wire I was told to reconnect on the terminal block 24 to 58 which should have been left unconnected.

See the machine had an air powered jig fitted to it and an out side on/off air switch. I was told to just remove it and jump the 2 wires for everything to work WRONG.

Now all I have to do is get the hand pendent working again.

Rick