[skullworks]

Title says it all;

There looks to be an un-used connector on the far right end of the Max32 system board, I'm guessing that could be for a kyb adaptor.

If so - can anyone give me the pin outs and any other helpful hints.

I had to remove the spindle motor and Z axis servo to get the machine through a door way, trying (slowly) to get things back in running order. The battle continues - I have to wire up the phase converter, and clean out the sump (KM3P) in the machine body.

[bloke]

When I get back to my laptop, I'm sure I could feed you the old pinouts but on a Max32, I'm not sure it would bring any benefits until you needed to re-load executive files from floppy...