Don't know what to expect because I've only seen my machine running. The question is: Do all these moves ramp up and down for each line of code or do most controllers do it without all the starts and stops.
I hereby acknowledge this may be a question from an ignoramus. Mr_C:tired:
Thread: Controller behavior
Results 1 to 1 of 1
-
12-28-2012, 06:40 PM #1
Registered
- Join Date
- Dec 2010
- Posts
- 0
Controller behavior
Reply With QuoteSimilar Threads
-
Strange behavior with VFD
By BanduraMaker in forum Gecko DrivesReplies: 3Last Post: 11-15-2011, 03:00 PM -
NM-200 - strange behavior?
By kvom in forum NovakonReplies: 1Last Post: 07-29-2011, 12:14 AM -
NM-200 - strange behavior?
By kvom in forum NovakonReplies: 3Last Post: 05-24-2011, 02:28 PM -
Strange Behavior.
By riveracnc in forum Mach Software (ArtSoft software)Replies: 2Last Post: 11-29-2008, 01:54 AM -
odd stepper behavior?
By opusinwood in forum Stepper Motors / DrivesReplies: 5Last Post: 07-05-2006, 01:30 PM
Posting Permissions
