Loaded a program into the milltronics machine and it errored out during the verification. Ran the program and for some reason after every hole it taps the machine sits over hole for a 100 second dwell all the sudden. Any ideas anybody?
Loaded a program into the milltronics machine and it errored out during the verification. Ran the program and for some reason after every hole it taps the machine sits over hole for a 100 second dwell all the sudden. Any ideas anybody?
have you indicated a P#??? if so you could have a wrong decimal point???
someone found the issue...it was one of the parameters that somehow had turned on that dwell.