Hi,

I have a 1988 promecam 100 ton with a hurco autobend 5. Since I've bought it (last year) I have difficulty getting the control working good. Sometime the back gauge work great all day long, but sometime it can be a pain... When I boot the control after a time it try to home the back gauge and it says peripheral reset. After a few reset (on and off) ohh the back gauge try to home but missing limit switch error is shown. So I reset a few more time and ohhh the back gauge home but says again peripheral reset. Sometime the back gauge place itself without error.... Is someone have an idea where the problem come from ?.

I have tried checking the wire all seem ok

Thanks a lot

Francis