How do you do a 5 axis contour in x5. normal to a surface?
Thanks
How do you do a 5 axis contour in x5. normal to a surface?
Thanks
I want to trim around the outside of a hand route fixture, need depth of cuts etc. tried curve and I can follow the curve normal to the surface, but no depth of cuts, not able to cut deeper than the surface.
250.00 TO e apprentice, learned to use a neg vector length and then depth cuts will work.
What class did you take was it the 5axis one?
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .
Yes it was, still going through them all. At least I got the operation done that I needed.
Great now if you have any question do not hesitate to contact the instructor and we will setup office time for you.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .
please PM me a contact email or phone number.
Are you going on today's Free Webinar? when you log into the class you find my email there. I am the instructor if you did not know.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .