Did you mean the chip was broken,
and have to reprogram the new PLC to the cnc machine?
can i burn the EPROM from other machine with same PLC?
or i need to reprogram the new one.
because i have the hard copy of PLC, but dont have the soft copy.
Did you mean the chip was broken,
and have to reprogram the new PLC to the cnc machine?
can i burn the EPROM from other machine with same PLC?
or i need to reprogram the new one.
because i have the hard copy of PLC, but dont have the soft copy.
Yes, I am referring to the plc software. The chip in location F81 (OE@) is defective. If you have an eprom programmer, you can read a good eprom to program a new eprom (don't trust the old one). Hard copy is useless, since you have to enter the info manually into the control. You don't have the ability to program from the control (we do!).