I am new to Rhinocam after several years of using Mastercam in a previous job and I am finding a few challenges.I have a job which spreads across a lot of sheets and the parts have been nested.This gives me the first obstacle as the three dimensional polysurfaces seem to cause the nesting module to react badly,so I have taken the curve representing the outline of the lower edge and it seems I have to align the polysurfaces with their outlines as a series of moves.Is there an easier way?
I have tried to machine some of the parts that have no three dimensional features as straight profiling cuts and I would like to know of an easy way to align the stock so that the posted file does not contain coordinates that are outside the building,never mind outside the machine's limits.I know that I could move each sheet to the origin,but is there a way to align the datum to each sheet?