Hi.
I just completed my second machine design after countless revisions.
it will be made from 1" square tubing for the frame and 3/4" mdf for the rest.
the cut area is about 19" x 30" x 3"
here are some drawings that you all can look at and give me some feedback before i start building.
Thread: My Second Machine Design
Results 1 to 6 of 6
-
01-19-2006, 05:19 PM #1
Registered
- Join Date
- Oct 2003
- Posts
- 208
My Second Machine Design
-
01-20-2006, 04:31 AM #2
Registered
- Join Date
- May 2005
- Posts
- 101
I like the improvement on the X-Axis, It looks to be Angle iron backing up the flex of the pipe?
-
01-20-2006, 05:35 AM #3
Gold Member
- Join Date
- Feb 2005
- Posts
- 578
Hard for me to tell. Is it square channel (or angle or plate) backing the X up? Why not do it for the Y also?
I think I see square channel supporting the X end plates, not a bad idea but this is not where you need to worry about flex.
Steve
-
01-20-2006, 03:16 PM #4
Registered
- Join Date
- Oct 2003
- Posts
- 208
Here is a drawing of the x axis support rail.
-
01-20-2006, 05:06 PM #5
Registered
- Join Date
- Oct 2003
- Posts
- 208
and here is a drawing of the y axis rail support assembly
-
01-20-2006, 11:32 PM #6
Gold Member
- Join Date
- Jun 2003
- Posts
- 3312
I made a pdf of the full view for those who can't see a dxf file:
Phil, Still too many interests, too many projects, and not enough time!!!!!!!!
Vist my websites - http://pminmo.com & http://millpcbs.com
Reply With Quote
Posting Permissions
