586,796 active members*
2,498 visitors online*
Register for free
Login

Thread: DNC question

Results 1 to 2 of 2
  1. 03-20-2003, 05:32 PM #1
    cncadmin
    cncadmin is offline Community Moderator
    Join Date
    Mar 2003
    Posts
    6855

    DNC question

    Can I use your DNC program with a stepper driven machine or does it req'er a machine with a servo controller?
    Thank You,
    Paul G
    www.rfqwork.com
    www.weldersforums.com
    Reply With Quote Reply With Quote
  2. 03-22-2003, 03:44 AM #2
    Merlin
    Merlin is offline Registered
    Join Date
    Mar 2003
    Posts
    37
    DNC is the connection between a PC and the machine control allowing for the download of an NC program to the machine. Does not have anything to do with stepper or servo...
    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. dx32 dnc
    By Alan bailey in forum Bridgeport / Hardinge Mills
    Replies: 10
    Last Post: 10-06-2020, 02:51 PM
  2. Extremely basic machining question.
    By touser in forum MetalWork Discussion
    Replies: 9
    Last Post: 06-19-2005, 06:51 AM
  3. DNC an old BPT BOSS
    By machintek in forum Bridgeport / Hardinge Mills
    Replies: 8
    Last Post: 05-20-2005, 11:30 PM
  4. Hobbycnc controler question
    By chas in forum Hobbycnc (Products)
    Replies: 3
    Last Post: 09-09-2004, 11:00 PM
  5. Dnc Faldal
    By motomitch1 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 5
    Last Post: 01-13-2004, 07:56 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules