hi all not sure if its in right section but here goes. my boss sent me down to leamington spa for training on fanuc controls all went well get back to our workshop and the menus on the machine are completely different to what i was training on. the machine i was trained on was a doosan mynx 7500 with a fanuc controller i think it was 0i controller it had in the manual guide a start, cycle and end soft key when programming whereas mine at work does not and all the menus are different is this normal or have i got to change something to get it the same ?
cheers jack
Results 1 to 3 of 3
-
10-14-2012, 01:33 PM #1
Registered
- Join Date
- Oct 2012
- Posts
- 0
vmc 610 xp2 fanuc 18i mb controller
-
10-18-2012, 12:53 PM #2
Registered
- Join Date
- Oct 2008
- Posts
- 44
Manual guide for Fanuc control is an option during purchase.
Normally we switch between Manual guide menu and ordinary Fanuc menu by the Custom button on the keypad, only if your control has the Manual guide option.
-
10-18-2012, 10:29 PM #3
Registered
- Join Date
- Oct 2012
- Posts
- 0
yeah our machine has a button called man guide instead of using the custom button
Reply With QuoteSimilar Threads
-
Fanuc Controller
By rrc in forum Uncategorised MetalWorking MachinesReplies: 9Last Post: 12-20-2021, 07:19 PM -
Fanuc oi-mc controller
By inkdaddy66 in forum Daewoo/DoosanReplies: 4Last Post: 06-23-2011, 02:43 PM -
can fanuc ac digital servo amplifiers be run by a controller other than fanuc?
By js412000 in forum Servo Motors / DrivesReplies: 5Last Post: 03-09-2011, 04:11 PM -
Fanuc 6M Controller
By QUALMACH1 in forum FanucReplies: 2Last Post: 02-03-2011, 04:02 PM -
Fanuc 20A controller
By HUEY2410 in forum FanucReplies: 3Last Post: 12-22-2010, 11:07 PM
Posting Permissions
