Where is there a good source for QC 30 tooling for my R2E3 Series 2??
Where is there a good source for QC 30 tooling for my R2E3 Series 2??
I believe that Kennemetal still makes this tooling but it is expensive.
When I had my R2E4 I went to MSC and Travers Tool for cheaper tool holders.
They should still be selling them.
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
ebay. I assume you mean NMTB 30
I've gotten almost everything I needed off of ebay. MSC carries NMTB 30 Enco has some a little cheaper.